U Nderstanding The D Isplay And Controls - Nautilus T514 Owner's Manual

sleeP Mode
When the unit is plugged into the outlet and the power switch/circuit breaker is turned from OFF to ON, the unit will
be in Sleep mode. the unit will automatically enter Sleep mode after 8 hours of inactivity. Pressing StOP while
in Standby mode will also bring the unit to Sleep mode, but this does not turn the treadmill power OFF. When the
treadmill is not in use, press StOP to turn the display off, then turn the power switch OFF and unplug the treadmill.
in Sleep mode all displays will be blank, even though the treadmill is plugged into the outlet and the power switch is
ON. Pressing any key on the treadmill except StOP will cause the displays to light up and the treadmill to enter Standby
mode.
understandInG tHe dIsPlay and controls
the treadmill display is a computerized panel used to operate the treadmill and display workout data and operational
status. Familiarize yourself with the operation of the treadmill and the location of all keys before using the unit.
treadMIll MaGnetIc saFety stoP cord and key
the safety stop cord attaches to the magnetic area located at the bottom of the display as shown. this
magnetic key is an emergency shut off and will abruptly stop the walking belt should you fall down or fall off the
treadmill while using the unit. unless there is an emergency, do not remove the safety stop cord while using the
treadmill. Always attach this safety stop cord
clip to your clothing during your workout.
Removing this magnetic key while not in use
will prevent children or unwanted users from
operating the treadmill. if the safety stop
cord is not fully inserted onto the magnetic
area located at the bottom of the display as
shown in Figure 4, the treadmill will NOt power up.
Figure 4
le display
instAllAtion And oPerAtion
imPORtANt!
le-X display
emergency stop Magnet
Nautlus® Sport Seres Treadmll Owner's Manual
AlWAyS At tACh the
SAFet y StOP CORd CliP
tO yOuR ClOthiNg duRiNg
WORKOut.
lC display
0