Installation And Operation T Readmill P Ower P Lug R Eceptacles - Nautilus T514 Owner's Manual

instAllAtion And oPerAtion
treadMIll Power PluG recePtacles
T514 & T516: the power plug receptacle is located on the front side of the motor pan. (See Figure 1.)
T518: the t518 treadmill has two power plug receptacles. this allows you to plug in the treadmill from the front or the
rear of the machine. the rear power cord receptacle, located behind a cover in the right rear end cap, should be used
if the treadmill is going to be placed in the center of the room facing away from the wall. to use the rear power inlet,
remove the AC inlet cover located in the right rear end cap with a Phillips screw driver. When the rear AC inlet cover is
not in use, replace the cover in the right rear end cap. the front power cord receptacle, located on the front side of the
motor pan, should be used if the treadmill is placed facing a wall or parallel to a wall. (See Figure 1.)
note: since the t518 has a front and rear
power inlet, there is a front/rear ac inlet
selection switch (Model t518 only). the
front power
setting. If you choose to use the rear
power inlet, move this switch in the
opposite direction (see Illustration to right).
Figure 1
attach power cord here
if your treadmill will
face away from the wall
(model t518 only).
I o

nstallatIon and PeratIon
inlet is the default factory
model t518 Front/Rear AC inlet Selector
attach power cord here
if your treadmill will be
facing a wall or will be
parallel to a wall.