Remote Controller Setup; Lock Setup - Integra DTR-30.4 Instruction Manual

Remote Controller Setup

1 2 3 4
"Setup"
Main Menu Remote Controller Setup
Remote ID
■
Remote ID
1, 2, or 3
When several Integra/Onkyo components are used in the
same room, their remote ID codes may overlap. To
differentiate the AV receiver from other components, you
can change its remote ID from "1", to "2" or "3".
Note
• If you do change the AV receiver's remote ID, be sure to change
the remote controller to the same ID (see below), otherwise, you
won't be able to control it with the remote controller.
Changing the remote controller's ID
1 While holding down Receiver, press and hold
down Q Setup until the remote indicator lights
(about 3 seconds).
2
Use the number buttons to enter ID 1, 2, or 3.
The remote indicator flashes twice.
Remote Mode Setup
See "Looking up for Remote Control Codes"
(➔ page 74).

Lock Setup

5 1 2
Main Menu
With this preference, you can protect your settings by
locking the setup menus.
■
Setup
Locked
Unlocked
When "Locked" is selected, the setup menus will be
locked and you cannot change any setting.
3 4 5
"Setup"
Lock Setup
En-67
Advanced Operations