Epson Stylus PRO Color Large Format Inkjet Printer 7000 Service Manual page 91

EPSON Stylus Pro 7000
Table 3-19. No Cartridge
Item
LCD
No Cartridge
message
LED indicator The Ink End indicator is on for the ink cartridge that is missing or
status improperly installed.
Details No ink cartridge installed or the ink cartridge is not fully installed.
Open the ink cartridge holder and install a new cartridge in the
empty slot. Do not use cartridges after removing them even one
time.
Recovery
If the cartridge is installed, and installed correctly, check the
operation and connection of the I/C detection sensor.
Do not insert used ink cartridges into the printer. Doing so will
cause the ink counter to function improperly.
Table 3-20. Option I/F Card
Item
LCD
Option I/F Card
message
LED indicator
N/A
status
An unsupported optional interface card is installed but cannot be
Details
used.
Turn off the printer, remove the unsupported option card, and
Recovery turn the printer back on. Install a supported option card if
necessary.
Troubleshooting
Description
Description
Troubleshooting Using the Error Messages
Table 3-21. Remove Paper
Item
LCD
Remove Paper
message
LED indicator
Paper Check LED is on.
status
Paper is too thick to allow for head cleaning.
Details
The currently loaded paper is too thick to allow for timed
cleaning.
Move the Paper Set Lever to the release position, remove the
paper, and return the Lever to the set position. Cleaning starts
Recovery and "Please Wait" appears on the LCD panel. When "No Paper
Loaded/Load Paper" appears, reload the thick paper to begin
printing.
Table 3-22. Cannot Print
Item
LCD
Cannot Print
message
LED indicator
Same as before this error arose.
status
Cannot perform test print.
Due to one or more of the following reasons the printer cannot
print a nozzle check pattern, status sheet, PG adjustment pattern,
or paper thickness pattern:
1) No paper loaded
Details
2) Ink cartridge missing
3) Paper recognition error
This error appears on the LCD panel for about three seconds,
and then the display returns to its previous state.
Exit SelecType mode and clear the error that appears on the LCD
Recovery
panel. Then return to SelecType mode and print.
Revision B
Description
Description
91