Panel Display Priority - Epson Stylus PRO Color Large Format Inkjet Printer 7000 Service Manual

EPSON Stylus Pro 7000
Table 1-29. Control Panel Messages (continued)
Display Message
When trying to print a test or adjustment
pattern, one of the following occurs:
• Paper not loaded
UNABLE TO PRINT
• Ink cartridge not loaded
• Paper detection error
• The paper was loaded too far forward and
• The paper's horizontal position exceeds the
RELOAD PAPER
• The paper's horizontal position exceeds the
• The cut sheet is too long and cannot be
• Recovery from cutter error.
Loaded paper is too thick to perform timer
REMOVE PAPER
cleaning
Pause state.
PAUSE
When total dots fired = 90%, cartridge enters
near-end condition. Remaining ink = A1 at
INK LOW
100% duty
Printer requires maintenance - see
MAINTENANCE REQ. nnnn
"Maintenance Request" on page 47
PRINTING * Processing print data.
• No paper loaded
• End of roll paper (printer stops feeding)
PAPER OUT
• End of sheet paper (when paper feeds to
Notes*: If the printer's platen gap setting is set to Thick, a "H" will appear in the
last space on the LCD display.
Product Description
Meaning
cannot be backward fed to the proper
position.
normal printable area when the paper is
loaded.
normal cutting area after printing.
ejected properly.
eject position, put hand under the sheet and
press Cut/Eject to release)

1.4.3 Panel Display Priority

High priority to low priority
Fatal errors/restart required
Reset, timer IC rest/NVRAM clear
Entering or in power-off sequence/transport preparation sequence
Entering or in ink-cartridge-replacement sequence
Cover open
Paper set lever released during operation
Type B interface error
No ink cartridge
Wrong ink cartridge
Ink out
Roll paper and sheet sizes are different
Paper jam
Paper set lever in release position
Paper cutting error
Paper not straight
Paper check error
Roll paper end
Paper eject error
Initializing
Paper is too thick for cleaning
Entering or in ink sequence
Waiting for paper-initialization trigger
Paused
Entering or in paper initialization
Entering or in ink drying time-out
Ink low/Maintenance required
Processing data/printer ready
Out of paper
Control Panel
Revision B
38