Epson Stylus PRO Color Large Format Inkjet Printer 7000 Service Manual page 131

EPSON Stylus Pro 7000
7. Using round-nosed pliers, remove the "Tension Spring, 9.9" from the C
head on the right.
Tension Spring, 9.9
Figure 4-36. Printhead Tension Spring and Screw Removal
8. Remove one screw (CB M3x6), also called the "H Spacer" screw, and then
remove the printhead from the carriage.
9. Remove the flat cable from the back of the printhead.
Figure 4-37. Printhead Removal
Disassembly & Assembly
Printhead
voltage ID
H Spacer screw
FFC
C head
Disassembly Flow
10. Repeat steps 7 through 9 for the B head.
When replacing the printheads, fold the flat cable behind
the printhead and make sure the printhead snaps fully
into place. When properly installed, the printhead ID will
be directly behind and at the same height as the PG Cam
Shaft. If the PG Cam Shaft does not partially block the line
of sight of the printhead ID (when looking at the ID level/
from straight in front), the printhead is not installed
properly.
When attaching the dampers to the printhead, follow the
same order, left to right, as shown on the control panel:
K, C, M, LC, LM, Y.
Revision B
131