System Stamp - Kyocera TASKalfa 3051ci User Manual

Management Settings
3.
4.

System stamp

System stamp settings
82
Specifies whether to use authentication traps. If enabled (On), an SNMP trap is
generated when an attempt to read or write is made using an incorrect community
name. The trap is sent to the configured trap address. After you have changed the
setting, you must restart the printing system.
Trap Recipient
Click Settings button to finalize the settings.
Configure SNMPv3 as follows. After you have changed the setting, you must restart the
printing system.
SNMPv3
Sets whether to use the SNMPv3 protocol. Select either On or Off in the Protocol
Settings page under Network Settings. To configure SNMP v3, proceed as fol-
lows.
Authentication
Sets whether the user authentication is performed in SNMP communication.
Hash
Select either MD5 or SHA1 for Hash algorithm. This item becomes active when the
Authentication is set to On.
Privacy
Sets whether to encrypt the communicated data in SNMP communication. This
becomes available when Authentication is set to On.
Encryption
Select either DES or AES for encryption algorithm. This item becomes active when
the Authentication is set to On.
Read Only User
Enter User Name and Password of the read-only user.
Read/Write User
Enter User Name and Password of the read/write user.
Click Submit button.
This section includes advanced settings that apply to the system stamp.
The system stamps include character and serial numbered stamps. Both are applied to
printing, sending, and storing jobs. For example, the following describes how to apply
the character and serial numbered stamps to a printing job.
Embedded Web Server