Dell 5100cn Color Laser Printer User Manual page 30

Ethernet
802.3
Ethernet
802.2
Ethernet
SNAP
Current Frame
Type
Network Address
NetWare Device Name*
Active Bindery:
Mode PServer
Mode
Bindery:
RPrinter
Mode
Directory:
PServer
Mode
Directory:
RPrinter
Mode
Tree Name*
Context Name
File Server
1
Name*
Print Server
1
Name*
Polling Interval
Receive Time-Out
NCP On
Packet
Burst
Off
Password
Confirm Password Allows you to confirm the configured password by re-entering the same password.
Status
Information
Logical Printer
Number
Selects IEEE802.3 frame type.
Selects IEEE802.2 frame type.
Selects SNAP frame type.
Displays the current frame type.
Displays the IPX network address.
Specifies the printer name up to 47 alphanumeric characters.
1
For PServer Mode, set the Print Server Name (Print Server Object Name). For RPrinter
Mode, set the Remote Printer Name (Printer Name in Bindery and Printer Object Name
in Directory). The original setting remains valid if no input is made.
Selects this option when using Directory: PServer Mode in Bindery: PServer Mode.
Selects this option when using Directory: RPrinter Mode in Bindery: PServer
Mode.
Selects this option when using Directory: PServer Mode in Bindery: RPrinter
Mode.
Selects this option when using Directory: RPrinter Mode in Bindery: RPrinter
Mode.
Specifies the tree name up to 32 alphanumeric characters. Configure this item only
1
when Directory: PServer Mode or Directory: RPrinter Mode is selected.
Specifies the context name of the Print Server Object up to 255 alphanumeric
characters. Configure this item only when Directory: PServer Mode or Directory:
RPrinter Mode is selected.
Specifies the file server name up to 47 alphanumeric characters. Configure this item
only when Bindery: PServer Mode or Bindery: RPrinter Mode is selected.
Specifies the print server name up to 47 alphanumeric characters. Configure this item
only when Bindery: RPrinter Mode or Directory: RPrinter Mode is selected.
Sets the time interval from when print data enters the print queue until printing starts.
The setting range is from 1 to 1000 seconds. The original setting remains valid if no
input is made. Configure this item only when Bindery: PServer Mode or Directory:
PServer Mode is selected.
Sets the timeout period that confirms data has been received. The setting range is
from 1 to 1000 seconds.
Uses NCP packet burst.
Does not use NCP packet burst.
Sets the print server password up to 32 alphanumeric characters. Configure this item
only when Bindery: PServer Mode or Directory: PServer Mode is selected.
Displays the messages according to the conditions of the printer.
Displays the printer number during Bindery: RPrinter Mode or Directory: RPrinter
Mode.