Dell 5100cn Color Laser Printer User Manual page 110

IP Filter
Purpose:
To specify the reception of data from certain IP addresses for blocking. You can set up to five IP addresses. The change
becomes effective after the printer is turned off and then on again.
Values:
Filter n Address
(n is 1 to 5.)
Mask
Mode Off*
Accept
Reject
Init NVRAM
Purpose:
To initialize network data stored in NVRAM.
Adobe Protocol
Purpose:
To specify PostScript communication protocol for each interface. You can configure Adobe Protocol settings for
Network. The change becomes effective after the printer is turned off and then on again.
Values:
Used when auto-detecting the PostScript communication protocol.
Auto*
Used when no special processing is required for data.
RAW
Used when the communication protocol is in ASCII interface.
Standard
Used when the communication protocol is in binary format.
BCP
Used when the communication protocol supports both ASCII and binary data to switch between them
TBCP
according to the specified control code.
USB
Use the USB menu to change printer settings affecting a USB port.
Adobe Protocol
Sets the IP address for Filter n.
Sets the mask for Filter n.
Disable the IP Filter feature for Filter n.
Accepts an access from specified IP address.
Rejects an access from specified IP address.