When Unable To Send Fax; Redial; Auto Redial Function; Redial Confirmation Screen - Konica Minolta bizhub C650 User Manual

Transmission
2.11

When unable to send fax

When IP address fax is used, if the fax cannot be sent because the recipient's line was busy, it can be
transmitted again by using the redial function.
The redial function of this function has auto redial, manual redial.
Note
The destination cannot be changed with auto redial or manual redial.
Even after redialing, when the fax cannot be sent because of problems with the line, refer to "Fax cannot
be sent (IP Address Fax)" on page 4-3.
There is no E-mail resending function in internet fax. When you cannot send a fax, refer to "Fax cannot
be sent (Internet Fax)" on page 4-2.

Redial

Dialing again at the same destination is known as redial.
When fax cannot be sent since the line of recipient's fax machine is busy, the number is redialed after the
lapse of the specific period. Before redialing, the sent job is treated to be job queued of the redial stand by.

Auto redial function

When it is unable to send the fax because the recipient's line is busy, it is automatically redialed as per the
auto redial function, which is set through the Line Parameter Settings.
!
Detail
In advance, the number of auto redials is specified as 3 times for 3 minutes in European models, 1 time
for 3 minutes in North American models. Refer to "Specifying Transmission/Reception Mode (Line
Parameter Settings)" on page 9-56 for the auto redial frequency settings.

Redial confirmation screen

When the fax cannot be sent due to the problem in the recipient's fax machine, the screen to confirm redial
is displayed.
1
Touch [OK].
Redialing begins after the setting time progresses.
When the transmission is not possible even after redialing, the display screen to confirm that it cannot
be terminated normally by the job, is displayed.
C650
2
2-35