Custom White Balance - FujiFilm FinePix S100 Owner's Manual

[SHOOTING MENU]

Custom white balance

A Select [
CUSTOM 1] or [
B Hold a piece of white paper under the light source for
setting the white balance, so that it fills entire the frame
in the screen. Then press the shutter button to set the
white balance.
CUSTOM WB CUSTOM WB
NEW WB NEW WB
NOT CHANGE NOT CHANGE
MEMO
To use the white balance set previously, press MENU/OK
without pressing the shutter button.
C When the correct exposure is measured,
[COMPLETED!] appears. Press MENU/OK to confirm
the setting.
COMPLETED! COMPLETED!
SET SET CANCEL CANCEL
92
CUSTOM 2] (➝p.85).
CANCEL CANCEL
ISO ISO 100 100
OVER OVER
F F
[OVER] or [UNDER]
Example
You can change the white balance for a photographed image
by using colored paper instead of white paper.
MEMO
• In AUTO mode, the correct white balance may not be
achieved for subjects such as close-ups of people's
faces and pictures taken under a special light source.
Select the correct white balance for the light source.
• When the flash fires, the white balance (except for
custom white balance) setting for the flash is used.
Consequently, to achieve a particular effect, the flash
mode should be set to Suppressed flash (➝p.77).
• The specified custom white balance is retained until it is
reset. This setting is retained even if the battery is
removed.
• The color tones may vary depending on the shooting
conditions (light source, etc.).
• After taking the picture, check the image color (white
balance).
• Explanation of Terms "White Balance" (➝p.171)
• Use the same ISO setting when custom white balance
was set, before shooting.
Setting the menu (➝p.85)
Set the exposure
compensation again, using
a negative value (–) when
[OVER] appears and a
positive value (+) when
[UNDER] appears (➝p.66).