Enable (Ospf) - Dell Force10 S2410-01-10GE-24P Command Reference Manual

The no version of this command is used to specify the access list to filter routes received from the
source protocol.
Mode Router OSPF Config

enable (OSPF)

This command resets the default administrative mode of OSPF in the router (active).
The no version of this command sets the administrative mode of OSPF in the router to inactive.
[no] enable
Syntax
Default
enabled
Mode Router OSPF Config
exit-overflow-interval
This command configures the exit overflow interval for OSPF. It describes the number of seconds after
entering overflow state that a router will wait before attempting to leave the overflow state. This allows
the router to again originate non-default AS-external-LSAs. When set to 0, the router will not leave
overflow state until restarted.
exit-overflow-interval 0-2147483647
Syntax
The range for seconds is 0 to 2147483647 seconds.
The
Default
0
Mode Router OSPF Config
external-lsdb-limit
This command configures the external LSDB limit for OSPF. When the number of non-default
AS-external-LSAs in a router's LSDB reaches the external LSDB limit, the router enters overflow
state. The router never holds more than the external LSDB limit non-default AS-external-LSAs in its
database. The external LSDB limit MUST be set identically in all routers attached to the OSPF
backbone and/or any regular OSPF area.
The no version of this command configures the default external LSDB limit for OSPF.
external-lsdb-limit limit
Syntax
no external-lsdb-limit
no
version of this command sets the exit overflow interval for OSPF to the default.
OSPF Commands | 431