Link Layer Discovery Protocol (LLDP)
Commands
The IEEE 802.1AB standard defines the Link Layer Discovery Protocol (LLDP). LLDP support is new
in SFTOS 2.5.1.
The commands in this chapter are:
•
•
•
•
•
LLDP Overview
LLDP allows a switch residing on an 802.1Q VLAN to advertise connectivity, physical description,
management information, and major capabilities. The TLV (Type/Length/Value) information distributed
via this protocol is stored by its recipients in a standard Management Information Base (MIB),
facilitating multi-vendor interoperability and use of standard management tools to discover and make
available physical topology information for network management.
To clear LLDP information:
—
clear lldp neighbors on page 159
—
clear lldp counters on page 159
To configure LLDP globally (on all ports):
—
lldp mode (global) on page 160
To configure LLDP on a single port:
—
lldp mode (interface) on page 161
level)
—
lldp notification on page 162
—
lldp transmit-mgmt on page 163
—
lldp transmit-tlv on page 163
To change default timers (all global):
—
lldp hello on page 160
—
lldp multiplier on page 161
—
lldp notification-interval on page 162
—
lldp timers-reinit on page 163
To display LLDP information:
—
show lldp interface on page 164
—
show lldp local-device on page 165
—
show lldp neighbors on page 166
—
show lldp remote-device on page 167
(timers not supported at interface
Link Layer Discovery Protocol (LLDP) Commands | 157
8