Ip Ospf Cost; Ip Ospf Dead-Interval - Dell Force10 S2410-01-10GE-24P Command Reference Manual

Command
History
Related
Commands

ip ospf cost

Syntax
Default
Mode
Command
History
Related
Commands

ip ospf dead-interval

Syntax
Default
| OSPF Commands
434
Version 2.3
interface range
interface vlan
ip ospf authentication
This command configures the cost on an OSPF interface.
ip ospf cost
1-65535
1-65535 represents the cost for the specified interface or VLAN.
The no ip ospf cost command configures the cost on an OSPF interface to the default.
10
Interface Config; Interface VLAN; Interface Range, which is indicated by the
(conf-if-range-interface)# prompt, such as (conf-if-range-vlan 10-20)#.
Version 2.3 Added Interface Range and Interface VLAN modes.
interface range Defines an interface range and accesses the Interface Range mode
interface vlan Creates a VLAN or selects an existing one and enters the Interface VLAN mode
This command sets the OSPF dead interval for the specified interface.
ip ospf dead-interval
seconds
The seconds parameter is a valid positive integer, which represents the length of time in seconds that a
router's Hello packets have not been seen before its neighbor routers should declare that the router is
down. The value for the length of time must be the same for all routers attached to a common network.
This value should be some multiple of the Hello interval.
Range: 1 to 2147483647
The no ip ospf dead-interval command sets the OSPF dead interval for the specified interface to
the default.
40 seconds
Added Interface Range and Interface VLAN modes.
ip ospf authentication
Modified: Separated
ospf authentication ip ospf authentication-key
and
encrypt
removed as a parameter.
Defines an interface range and accesses the Interface Range mode
Creates a VLAN or selects an existing one and enters the Interface VLAN
mode.
Sets the OSPF Authentication Type and Key for the specified interface.
ip
into two commands—
, and