•
•
•
•
dvlan-tunnel l2pdu-forwarding enable
This command is used to enable/disable the l2pdu-forwarding mode, used for BPDU tunneling.
[no] dvlan-tunnel l2pdu-forwarding enable
Syntax
The no version of this command disables the l2pdu-forwarding mode.
Default
Enable
Mode
Global Config
Command
Version 2.5.2
History
Version 2.5.1
Version 2.3.1.9
Related
dvlan-tunnel
Commands
l2pdu-forwarding
mac-address
show dvlan-tunnel
l2pdu-forwarding
show dvlan-tunnel
dvlan-tunnel l2pdu-forwarding mac-address
This command sets/clears the l2pdu-forwarding MAC address.
[no] dvlan-tunnel l2pdu-forwarding mac-address mac-addr
Syntax
Default
01:01:E8:00:00:00
Mode
Global Config
Command
Version 2.5.2
History
Version 2.5.1
Version 2.3.1.9
mode dvlan-tunnel on page 153
show dot1q-tunnel on page 154
show dvlan-tunnel on page 155
show dvlan-tunnel l2pdu-forwarding on page 155
Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
Introduced
Set/clear the l2pdu-forwarding MAC address.
Displays the current l2pdu tunneling configuration on the switch.
Displays whether an interface is enabled for Double VLAN Tunneling, along with
the system-configured etherType and detailed information about Double VLAN
Tunneling for the specified interface, or a list of interfaces and their tunneling status.
Unsupported: This command was not tested in SFTOS 2.5.2, so is not supported
Unsupported: This command was not tested in SFTOS 2.5.1, so is not supported
Introduced
VLAN Commands | 151