Related
show inlinepower (stack)
Commands
show inlinepower
inlinepower threshold
Configure the amount of Power over Ethernet (PoE) allotted for a specified switch in the S-Series
stack. The amount is specified as a percentage of the total possible power budget.
inlinepower threshold 0-100 unit-id
Syntax
Parameters
0-100
unit-id
Defaults
80 (80% (288 Watts) of the total possible power budget)
Mode
Global Config
Command
Version 2.5.1
History
Related
show inlinepower (stack)
Commands
show inlinepower
inlinepower admin
Enable or disable the Power over Ethernet (PoE) feature on a particular port. Once disabled, that port
can no longer supply power.
inlinepower admin {off | auto}
Syntax
Parameters
off
auto
Defaults
Mode
Interface Config; Interface Range Ethernet
Command
Version 2.5.1
History
Related
show inlinepower (stack)
Commands
show inlinepower
Introduced
auto
|
Introduced
Display PoE status of stack members.
Display PoE status of designated port.
Enter an integer from 1 to 100, representing the percentage of the total power
budget to make available to the specified switch in the S-Series stack. By
default, 80% (288 Watts) of the total possible power budget is available.
Enter the stack member ID of the switch to which you want to change the
PoE setting.
Display PoE status of stack members.
Display PoE status of designated port.
auto
Enter
to allow the selected port to supply power.
off
Enter
to stop the selected port from supplying power.
Display PoE status of stack members.
Display PoE status of designated port.
System Configuration Commands | 115