Connecting To The Ethernet Interface - Ricoh Type 2075 Operating Instructions Manual

Connecting to the Ethernet
Interface
The network interface board supports
10BASE-T or 100BASE-TX connec-
tions.
Important
❒ Before making the connection,
touch the metallic part to ground
yourself.
A A A A
A core for the Ethernet cable is
s upp lied with this machine.
Make a loop at the end of the Eth-
ernet cable, and then attach the
core as shown below.
B B B B
Turn off the main power switch.
Important
❒ Make sure the main power is
off. See "Turning On the Pow-
er", General Settings Guide.
C C C C
Connect the Ethernet interface ca-
ble to the 10BASE-T/100BASE-TX
port.
D D D D
Turn on the main power switch.
1.
Indicator (green)
Remains green when the machine is
properly connected to the network.
2.
Indicator (yellow)
Turns yellow when 100 BASE-TX is
operating. Turns off when 10 BASE-T
is operating.
AEW017S
AEW012S
Connecting the Machine
ZKRH050E
1
13