Connecting The Machine; Requirements; Connecting The Machine To The Host Using The Parallel Cable/Ieee 1394 (Scsi Print) Cable - Ricoh Type 2075 Operating Instructions Manual

Getting Started

Connecting the Machine

Reference
1
For information about connection
using Ethernet and wireless LAN,
see "Confirming the Connection",
Network Guide.
For information about connection
using Bluetooth
that comes with the optional Blue-
tooth interface unit.

Requirements

Before using this machine, make sure
all environmental and electrical re-
quirements are met. Connect the ma-
chine to the host computer using the
parallel port, network interface unit,
or both.
Make sure all cables, connectors, and
electrical outlets necessary to attach
the machine to the host computer or
network are at hand.
Connecting the Machine to the
host using the parallel
cable/IEEE 1394 (SCSI print)
cable
Connect the machine to the host com-
puter using the parallel port or op-
tional IEEE 1394 interface board. This
machine does not come with a paral-
lel cable to connect the machine to the
host computer.
The machine's parallel interface is a
standard bidirectional interface. It re-
quires a standard IEEE 1284 compli-
ant 36-pin parallel cable and a parallel
port on the host computer. Make sure
you purchase the appropriate cable
for the machine and your computer.
10
TM
, see the manual
Note
❒ Do not use a parallel cable that is
longer than 3 meters (10 feet).
❒ Rating voltage of the interface con-
nector: Max. DC 5V
Follow the procedure below to con-
nect the machine to the host computer
using a parallel cable or IEEE 1394 in-
terface cable.
Important
❒ Before connecting the machine and
a computer using an interface ca-
ble, make sure the machine is not
operating, and then turn off the
main power switches of the ma-
chine and computer.
❒ Be sure to use a specified interface
cable. Other cables may cause ra-
dio interference.
A A A A
If you use the parallel port, pro-
B B B B
ceed to step . If you use IEEE
1394 interface, proceed to step
B B B B
Clip the ferrite core around the
printer end of the cable, close to
the connector.
Note
❒ The ferrite core (1 Piece) and tie
wraps (2 pieces) for the Ethernet
cable is supplied with this ma-
chine.
F F F F
.
AEW022S