Connecting The Machine; Connecting To The Ethernet Interface - Ricoh All in One Printer Operating Instructions Manual

1. Connecting the Machine

This chapter describes how to connect the machine to the network and specify
the network settings.
Before using this machine, make sure all environmental and electrical require-
ments are met. Connect the machine to the host computer using the USB port or
network interface unit. Make sure all cables, connectors, and electrical outlets
necessary for attaching the machine to the host computer or network are close at
hand.

Connecting to the Ethernet Interface

The network interface board supports 10BASE-T or 100BASE-TX connections.
Important
❒ Make sure the main power is off.
A
Turn off the main power switch.
B
Connect the network interface cable to the 10BASE-T/100BASE-TX port.
C
Turn on the main power switch.
Check the LEDs on the 10BASE-T/100BASE-TX port.
1.
Indicator (green)
Remains green when the machine is
properly connected to the network.
Reference
"Turning On the Power", About This Machine.
ARG005S
AAW022S1
2.
Indicator (yellow)
Turns yellow when 100 BASE-TX is
operating. Turns off when 10 BASE-T
is operating.
7