Honda CB TWISTER Owner's Manual page 73

Installation Notes:
• Reverse the removal procedure.
• Tighten the rear axle nut and brake
stopper arm nut to specified torque.
Rear axle nut torque:
54 N.m (5.5 kgf.m, 40 lbf.ft)
Brake stopper arm nut torque:
22 N.m (5.5 kgf.m, 40 lbf.ft)
• Adjust the brake (page 14-15) and
drive chain (page 54).
• After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
• Always replace used cotter pins with
new ones.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
Brake pad wear (Disc Type)
Refer to the safety precautions on page 40.
Brake pad wear depends upon the severity
of usage, the type of riding, and road
condition. (Generally, the pads will wear
faster on wet and dirty roads.)
Inspect the pads
maintenance interval (page 42).
Check the grooves (1) in each pad. If either
pad is worn to the bottom of the grooves,
replace both pads as a set. See your Honda
dealer for this service.
(1) Wear indication grooves
at each regular
¼f?klkoV la d s r d xz w O l½
65