Honda CB TWISTER Owner's Manual page 72

REAR WHEEL REMOVAL
1. Place the vehicle on its center stand.
2. Remove the rear brake adjusting nut
(1). Disconnect the brake rod (2) from
the brake arm (3).
(1) Brake adjusting nut ¼cz s d ,MtfLVa x uV½
(2) Brake rod
¼cz s d jks M ½
(3) Brake arm ¼cz s d vkeZ ½
(4) Brake stopper arm ¼cz s d LVkij vkeZ ½
(5) Cotter pin
¼dkW V j fiu½
(6) Stopper arm nut ¼LVkW i j vkeZ uV½
(7) Rear axle nut ¼fj;j ,Dly uV½
64
3. Disconnect the brake stopper arm (4)
from the brake panel by removing the
cotter pin (5), stopper arm nut (6),
washer and rubber grommet.
4. Remove the rear axle nut (7).
5. Remove the rear axle shaft (8), side
collar and rear wheel from the
swingarm.
(8) Rear axle shaft ¼fj;j ,Dly "kk¶V½