Honda CB TWISTER Owner's Manual page 71

Installation Notes:
• Reverse the removal procedure.
• Position the wheel between the fork legs
and insert the front axle from the right
side, through the right fork leg and
wheel hub.
• Tighten the front axle nut to specified
torque.
Front axle nut torque:
54 N.m (5.5 kgf.m, 40 lbf.ft)
• Make sure that the tang (8) on the left
front fork leg is located in the slot (9) in
the brake panel.
• Adjust the brake (page 14-15).
• After installing the wheel, apply the
brake several times and then check if
the wheel rotates freely. Recheck the
wheel if the brake drags or if the wheel
does not rotate freely.
If a torque wrench was not used for
installation, see your Honda dealer as soon
as possible to verify proper assembly.
Improper assembly may lead to loss of
braking capacity.
(8) Tang
¼VS a x ½
(9) Slot ¼LykW V ½
63