To Adjust The Density On A Solid Colored Image - Toshiba e-STUDIO6520c Imaging Manual

1.2 To Adjust the Density on a Solid Colored Image

If the density is decreased
The solid colored area becomes lighter.
Explanation
In thick paper printing, the density of a solid colored image can be made darker to enhance it or lighter in order
to match with the type or color of the original.
<Notes> • The function described in this chapter cannot be used for plain paper 1 and 2 in the full color
mode.
The type of plain paper 1 and 2 is as follows.
Paper type not available
Full color
Do not use the following code corresponding to plain paper 1 and 2 for the adjustment.
Full color /
Black
• When performing the adjustment in accordance with the procedure, note that the density of a
gradation area (halftone), such as a photograph, is adjusted as well as that of a solid colored
image.
e-STUDIO5520C/6520C/6530C
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
Plain paper 1
Plain paper 2
Paper type
Plain paper 1, 2
1-5
If the density is increased
The solid colored area becomes darker.
Acceptable paper weight
64 to 80g/m² Max. 20 lb. Bond
81 to 105g/m² Max. 28 lb. Bond
Color to adjust [08] code
Y (yellow)
M (magenta)
08-2513
C (cyan)
K (black)
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Subcode
0
1
2
3