Toshiba e-STUDIO6520c Imaging Manual page 213

Procedures
* The service technician must perform all adjustments.
PCL6 PS3 XPS
(1) Enter adjustment mode [05]. Decrease the values for codes [8070/8071] or [8089/8090] to reduce the limit
value of the maximum amount of toner used.
• Adjust the value for [05] code corresponding to the print option to be applied (Paper type and Halftone).
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Resolution Halftone
Smooth
600dpi
Detail
Smooth
1200dpi
Detail
* Set the value in increments of approximately 30, while checking the printouts until the optimum value is
obtained.
Subcode Paper type
0 Plain paper 1
1 Plain paper 2
2 Recycled paper
3 Thick 1
4 Thick 2
5 Thick 3
6 Thick 4
7 Special 1
8 Special 2
9 OHP
Caution after the adjustment
The adjustment may possibly cause dark areas such as shades on photo images to look unnaturally faint.
Therefore, carefully perform the adjustment, while checking the printouts.
e-STUDIO5520C/6520C/6530C
* This adjustment will have an effect only on Auto or Color mode printing.
Mac
[05] code Subcode
05-8071 0/1/2/3/4/5/6/7/8/9
05-8070 0/1/2/3/4/5/6/7/8/9
05-8090 0/1/2/3/4/5/6/7/8/9
05-8089 0/1/2/3/4/5/6/7/8/9
3-93
3. Printer-specific Adjustments
Recommended
value
Set a value smaller
than the default.
Set a value smaller
than the default.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Acceptable
Default
value range
0 to 255 128
0 to 255 128