Toshiba e-STUDIO6520c Imaging Manual page 54

2. Copier-specific Adjustments
(4) Enter adjustment mode [05]. Change the values for codes [1779 to 1798] to adjust the color density.
Color to
Original mode [05] code Subcode
adjust
Text/Photo
Text
Y
Printed image
(Yellow)
Photo
Map
Text/Photo
Text
M
Printed image
(Magenta)
Photo
Map
Text/Photo
Text
C
Printed image
(Cyan)
Photo
Map
Text/Photo
Text
K
Printed image
(Black)
Photo
Map
* Set the value in increments of approximately 10, while checking the copy image until the optimum value is
obtained.
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode
0
1
2
After setting the values, copy and check the copy image quality.
Only if the vividness of R (Red) is still insufficient even after all the above procedures have been used, must
the service technician use the next procedure.
e-STUDIO5520C/6520C/6530C
05-1779 0/1/2
05-1780 0/1/2
05-1781 0/1/2
05-1782 0/1/2
05-1783 0/1/2
05-1784 0/1/2
05-1785 0/1/2
05-1786 0/1/2
05-1787 0/1/2
05-1788 0/1/2
05-1789 0/1/2
05-1790 0/1/2
05-1791 0/1/2
05-1792 0/1/2
05-1793 0/1/2
05-1794 0/1/2
05-1795 0/1/2
05-1796 0/1/2
05-1797 0/1/2
05-1798 0/1/2
Area where the density is adjusted
Low-density area
Medium-density area
High-density area
2-20
Recommended value
Set a value larger than 128
to increase the density.
Set a value smaller than 128
to decrease the density.
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Acceptable
Default
value range
0 to 255 128