Toshiba e-STUDIO6520c Imaging Manual page 8

Table of Contents
2.16 To Adjust the Twin-Color Copy Image Quality ............................................2-66
2.16.1 To Adjust the Tint of Colors other than Black ...........................................2-67
2.16.2 To Adjust the Reproducibility of Black in the Red and Black Mode ..........2-68
2.16.3 To Adjust the Boundary between Black and Colors other than Black.......2-69
2.17 To Adjust the Image Quality Scanned from the RADF................................2-70
2.18 To Program Frequently Used Copy Settings (To Use Custom Mode) .......2-73
2.18.1 To Adjust Custom Mode Settings in Black Mode......................................2-73
2.18.2 To Adjust Custom Mode Settings in Color Mode ......................................2-78
2.19 To Copy While Erasing Shadow Outside of Image .....................................2-82
2.20 To Avoid Copying Blank Page of Original Scanned with RADF..................2-83
2.21 To Obtain Image in Even Density Level......................................................2-85
3. Printer-specific Adjustments
Restrictions on Use of Printer Functions................................................................3-1
3.1 To Maintain a Steady Color Balance.............................................................3-2
3.2 To Maintain a Steady Color Balance on Thick Paper or Special Paper ..............3-4
3.3 To Obtain the Desired Color Balance ...........................................................3-6
3.4 To Closely Match the Color Balance on the Monitor ...................................3-14
3.5 To Maintain a Uniform Gray Hue
(To maintain Consistency in Gray among Text, Photos and Graphics) ..3-17
3.6 To Use Only the Black Toner to Reproduce Gray Areas
(To use only the black toner to reproduce black-and-white photos or
gradational images) ................................................................................3-20
3.7 To Easily Adjust the Overall Brightness ......................................................3-24
3.8 To Adjust the Overall Saturation .................................................................3-27
3.9 To Easily Adjust the Overall Contrast .........................................................3-31
3.10 To Obtain a Sharper Print Image ................................................................3-34
3.11 To Obtain a Softer Image............................................................................3-37
3.12 To Make Low-resolution Data Look Finer (To soften an image) .................3-40
3.13 To Eliminate Smudges from Highly Colored Text and Lines
(To prevent toner scattering around text and lines where a large amount of
toner is used) ..........................................................................................3-43
3.14 To Clearly Print Light-Colored Thin Lines or Text .......................................3-47
3.14.1 To Adjust the Print Image Quality in the Color Mode................................3-48
3.14.2 To Adjust the Print Image Quality in the Black and White Mode ..............3-56
3.15 To Make the Light-Colored Area Darker on the Printout .............................3-60
3.16 To Clearly Print Thin Lines/Double Lines....................................................3-66
3.17 To Decrease the Image Density and Save Toner
3.18 To Adjust the Image Density in the Toner Save Mode................................3-74
3.19 To Print Illegible Gray or Colored Text in Black ..........................................3-77
e-STUDIO5520C/6520C/6530C
(To Print in the Toner Save Mode) ..........................3-71
© 2008 TOSHIBA TEC CORPORATION All rights reserved
ii