Toshiba e-STUDIO6520c Imaging Manual page 23

(b) Enter the setting mode [08]. Change the value of the codes [5293/5294/5296] to adjust fusing
temperature in the recycled paper mode. (In this step fusing temperature is adjusted to print the
high-density area of the image most clearly.)
Adjustment
Center heater
Side heater
Center
Pressure
roller
Side
• After adjusting the fusing temperature, perform automatic calibration.
* Refer to step (1) in "1.1 To Obtain a Darker Image".
<Hint> The smaller the setting value, the lower the fusing temperature becomes. It is usually
recommended that the set value be decreased in order to suppress roughness on the high-density
area of the image. Adjust the value within the range of the recommended values while checking
the image carefully because if it is too small, insufficient fusing may occur.
Since temperatures on the long side of the paper cannot be kept in a proper balance, the same
value must be set for the [08] codes [5293] and [5294] unless otherwise required so.
After setting the value, print and check the image quality.
If further image quality adjustment is necessary, go to step (3).
e-STUDIO5520C/6520C/6530C
1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
Paper
[08] code
type
Black
Recycled
08-5293
paper
Color
Black
Recycled
08-5294
paper
Color
Black
Color
Recycled
08-5296
paper
Black
Color
© 2008 TOSHIBA TEC CORPORATION All rights reserved
1-13
Recommen
Subcode
ded value
0
7 to 10
1
0
7 to 10
1
0
1 to 6
1
2
1 to 6
3
Accepta
ble value Default
range
10
0 to 16
8
10
0 to 16
8
3
0 to 16
1
3
0 to 16
1