Toshiba e-STUDIO6520c Imaging Manual page 87

(4) Enter adjustment mode [05]. Change the values for codes [1779], [1780], [1784], [1785], [1789], [1790],
[1794], [1795] or [7980] to [7983] to adjust the density level of each color.
Color to
Original mode
adjust
Text/Photo
Y
Text
(Yellow)
User custom
Text/Photo
M
Text
(Magenta)
User custom
Text/Photo
C
Text
(Cyan)
User custom
Text/Photo
K
Text
(Black)
User custom
* Set the value in increments of approximately 10, while checking the copy image until the optimum value
is obtained.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode
0
1
2
Caution after the adjustment
The adjustment may possibly cause a dark-colored area, such as in a photo, to become blurred on the copy. Also,
it may also cause offset failure, grained images and degradation in gradation. Therefore, carefully perform the
adjustment, while checking the copy image.
e-STUDIO5520C/6520C/6530C
[05] code
05-1779
05-1780
05-7980
05-1784
05-1785
05-7981
05-1789
05-1790
05-7982
05-1794
05-1795
05-7983
Area where the density is adjusted
Low-density area
Medium-density area
High-density area
2-53
2. Copier-specific Adjustments
Recommended
Subcode
value
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
0/1/2
Set a value larger than
128.
0/1/2
0/1/2
0/1/2
0/1/2
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Accep
table
Default
value
range
0 to
128
255