Toshiba e-STUDIO6520c Imaging Manual page 16

1. General Adjustments – Copying, Printing and e-Filing (Output from Box)
Procedures
* The service technician must perform the adjustment in accordance with the procedures below.
(1) Enter setting mode [08]. Change the value to adjust the density of a solid area during the copying/printing
operation.
• Use steps (a) to (b) to perform the adjustment.
(a) Enter setting mode [08]. Change the values for codes [2514/2515/2546] to adjust the developer bias
output value.
* The value to use varies depending on the paper type and color to adjust. Check the code to use in
accordance with the following "Code" list, and refer to the "Value" list to select a proper value.
In the Full color mode
Paper type
Full color
In the Black mode
Paper type
Black
* 08-2515 is available for e-STUDIO6530C only.
* The table below shows you the acceptable paper weight for the paper type.
Paper type
Full color /
Black
Full color /
Black
e-STUDIO5520C/6520C/6530C
Color to adjust
Y (yellow)
M (magenta)
Thick 1, 2
C (cyan)
K (black)
Y (yellow)
Thick 3, 4 M (magenta)
Special 1, 2
C (cyan)
K (black)
Color to adjust
Plain paper 1, 2 K (single color)
K (single color: When thick
Thick 1 to 4
paper is used in the Black
mode)
K (single color: When
Special 1, 2 special paper is used in the
Black mode)
Thick 1 106 to 163 g/m²
Thick 2 164 to 209 g/m²
Thick 3 210 to 256 g/m²
Thick 4 257 to 300 g/m²
Special 1
Special 2
1-6
[08] code
08-2514
08-2546
[08] code
08-2515 *
08-2514
08-2546
Acceptable paper weight
Max. 60 lb. Cover
Max. 110 lb. Index
Max. 140 lb. Index
Max. 110 lb. Cover
Water-resistant paper (CoLaCa)
Glossy paper (Eco-crystal)
© 2008 TOSHIBA TEC CORPORATION All rights reserved
Subcode
0
1
2
3
0
1
2
3
Subcode
---
3
3