Toshiba e-STUDIO6520c Imaging Manual page 196

3. Printer-specific Adjustments
To adjust the image quality on Black and White printing
("Black and White" is selected from among the "Color" options on the PCL6 or PS3 or XPS printer driver.
"Mono" is selected from among the "Color Type" options on Macintosh.)
* The "Color" options are available in the "Basic" tab on the PCL6, PS3 and XPS printer drivers. The
"Color Type" options are available in the "Color Settings 1" menu in the print dialog box on Macintosh.
(a) Enter adjustment mode [05]. Increase the value for codes [664] or [7302] to adjustment the upper limit
of the image density in the toner save mode.
* Printing on Macintosh is performed in PostScript. (See the "PS3" row in the table below.)
Resolution PDL
PS3
PCL6
600dpi
XPS
PS3
PCL6
1200dpi
XPS
* Set the value in increments of approximately 10, while checking the printouts until the optimum value
is obtained.
Caution after the adjustment
The adjustment may possibly cause an increase of the amount of toner used (if the image density is increased) or provide
faint print images (if the image density is decreased). Therefore, carefully perform the adjustment, while checking the
printouts.
e-STUDIO5520C/6520C/6530C
[05] code Subcode
05-664 0
05-664 1
05-664 2
05-7302 0
05-7302 1
05-7302 2
© 2008 TOSHIBA TEC CORPORATION All rights reserved
3-76
Recommended Acceptable
value value range
Set a value smaller
than 176 to decrease
the density.
0 to 255
Set a value larger
than 176 to increase
the density.
Set a value smaller
than 176 to decrease
the density.
0 to 255
Set a value larger
than 176 to increase
the density.
Default
176
176