Adjustment Of Image Density - Toshiba e-STUDIO163 Service Handbook

3.3.7

Adjustment of image density

The image density level can be set at the following codes.
Code
667-0 to 4 Adjustment of image density
<Procedure>
(1) While pressing [0] and [5] simultaneously, turn the power ON.
(2) Key in the code "667" and press the [START] button.
(3) Key in the sub code (0, 1, 2, 3 or 4), and press the [START] button.
(4) Key in an adjustment value.
(To correct the keyed-in value, press the [CLEAR] button.)
(5) Press the [ENTER] or [INTERRUPT] button to store the value in memory. The equipment goes
back to the ready state.
(6) For resetting the value, repeat step (2) to (5).
(7) Turn the power OFF and then back ON to perform printing job.
(8) If the desired image density has not been attained, repeat step (2) to (7).
December 2005 © TOSHIBA TEC
Item to be adjusted
3 - 23
< Adjustment Mode (05) >
Remarks
When the value is decreased, text becomes lighter.
Acceptable values: 0 to 63
Notes:
1. Set not to reverse the large and small num-
ber of the setting value corresponding to the
sub code.
Ex.) When substituting the setting value for
667-0 with A0, • • •, 667-4 with A4: A0 A1 A2
A3 A4
2. Remember that the image specifications
and life span of the replacing parts may not
meet the standard when the setting value is
changed from the default value.
e-STUDIO163/203 ADJUSTMENT
3