Toshiba e-STUDIO6520c Imaging Manual page 94

2. Copier-specific Adjustments
* The value for the code corresponding to the original mode (Text/Photo, Text, or Printed image) will affect
the copy image quality in the Full color mode and the Auto color mode.
* The subcode varies according to the area where the density is adjusted. Refer to the table below and set
the subcode for the area to be adjusted.
Subcode
0
1
2
Caution after the adjustment
Nothing in particular.
Remarks
• Enter a value within the recommended value range mentioned in the procedures. Otherwise, it may cause a
loss in MFP performance, including degradation in the image quality and a reduction in the life of the
consumables
• If the adjustment causes a toner fixing problem, decrease the values for codes 05-1613 to 1618.
e-STUDIO5520C/6520C/6530C
Area where the density is adjusted
Low-density area
Medium-density area
High-density area
2-60
© 2008 TOSHIBA TEC CORPORATION All rights reserved