EE Brightbox User Manual page 50

Broadband Username
Broadband Password
Protocol
VLAN (Bridging
Protocol only)
VPI/VCI (ADSL
Broadband Type
only)
Encapsulation (ADSL
Broadband Type
only)
ADSL or Fibre broadband services however is to use the
Migration Wizard page.
This field is used to configure your PPPoA or PPPoE
Username provided by your ISP.
EE Broadband customers must remember to add @fs to
the end of the Username (for example
yourname.orangehome.co.uk@fs.
This field is used to configure your Broadband Password
provided by your ISP. The field cannot be left empty.
This dropdown allows you to configure the connection
protocol for the particular Broadband Type. By default this
value is 'PPPoA' for ADSL broadband or 'PPPoE' for Fibre
broadband.
Select 'PPPoA' for PPP over ATM connectivity. This is the
correct value for EE ADSL broadband customers. You must
enter a Broadband Username and Broadband Password to
establish an Internet connection
Select 'PPPoE' for PPP over Ethernet connectivity. This
option is available for both ADSL and Fibre/Ethernet
broadband types. You must enter a Broadband Username
and Broadband Password to establish an Internet
connection.
Select 'Bridging' to set the router to act as a bridge to
pass Internet traffic directly to the attached client PC
from another modem. This option is available for
Fibre/Ethernet broadband types only.
Select 'Routing' to set the router to route Internet traffic
over the Ethernet connection where authentication is
handled by a modem. This option is available for
Fibre/Ethernet broadband types only.
This dropdown allows you to select the Virtual LAN group
the Bridged Internet connection is associated with in
order to configure separate internal networks. The
'default' VLAN is select by default.
This dropdown will only be visible if the 'Broadband Type'
is set to 'Fibre/Ethernet' and the 'Protocol' option of
'Bridging' is selected.
The VLAN settings are configured in Advanced Set-Up
> DHCP page. See DHCP on page 122 for further
information.
This field is used to configure the ATM Virtual Path
Identifier (VPI) and Virtual Channel Identifier (VCI) for the
active Internet connection.
For EE ADSL broadband the default value is '0/38'.
Entering other values may prevent you connect to the
Internet.
This field is not visible for the Fibre/Ethernet Broadband
Type.
This dropdown allows you to configure the ATM
Encapsulation setting for the active Internet connection.
For EE ADSL broadband the default value is 'VC MUX'.
EE Bright Box User Manual
50