EE Brightbox User Manual page 35

> WEP
> WPA
> 802.1x
> Bandwidth Control
USB File Sharing
Mobile Broadband
DHCP
NAT
This advanced page allows you to configure the WEP
wireless security settings for any of the transmitting
SSID's. Settings include the WEP mode (64 or 128-
bit), Key Entry type (Hex or ASCII), WEP passphrase
and WEP key generation.
Please note that WEP security can only be
configured with the router set to '11b+11g' wireless
mode.
This page contains settings allowing you to
configure the WPA wireless security settings for any
of the transmitting SSID's. Settings include WPA
Mode (WPA, WPA2 or WPA/WPA2 Mixed Mode),
Cipher Suite (Auto, AES or TKIP), Authentication
Type (Wireless Password or 802.1x), Wireless
Password type (Passphrase or Hex) and the WPA
Wireless Password.
This page contains configuration settings for 802.1x
RADIUS wireless authentication. 802.1x can be
enabled or disabled on this page (disabled by
default). Other settings include re-authentication
and quiet period times and RADIUS server
parameters.
This page allows configuration of wireless
Bandwidth Control for each of the wireless SSID's.
This allows you to set a maximum throughput limit
for upstream or downstream traffic.
Please note that the QoS module must be enabled
for this feature to work (see Bandwidth Control on
page 112)
Advanced USB File Sharing options can be found in
this page. As with the Basic Set-Up page, Auto
Sharing option and workgroup names can be
configured here. Additional features include
enabling/disabling Samba, creating user accounts, a
connected USB device list and NAS folder sharing
settings.
Mobile Broadband support can be enabled on this
page, to allow use of 3G mobile Internet connections
with supported 3G USB dongles. The page displays
the current 3G connectivity status and PIN codes.
Please note that this is currently only a beta feature.
This page contains configuration options for DHCP
in order for the router to dynamically allocate IP
addresses to your client PC's. The DHCP server can
be enabled/disabled on this page and DHCP address
reservation set-up. Other settings such as
Gateway/Subnet IP addresses, Lease Time, Domain
Name and DHCP Start/End ranges can be configured
here.
The NAT (Network Address Translation) setting can
be disabled/enabled on this page. Please note that
this feature is enabled by default.
EE Bright Box User Manual
35