Baby Lock Pro-Stitcher BLPS Instruction And Reference Manual page 19

The Design Library lists folders on the lower left-
hand side and the actual patterns within those fold-
ers on the right-hand side. A preview of the selected
pattern is shown in the upper left-hand block. To
browse through the USB flash drive, the following
functions must be understood (Figure 7).
Current Path: The line just below the "Back" and
"Options" tabs on the lower left-hand section shows
the current path the Pro-Stitcher is looking at to find
the patterns (Figure 7). The drive letter at the begin-
ning of the current path should be "E:\". If there are
not any yellow folders listed below the current path
on the left, and there are no patterns on the right,
try pressing the "Back" button until the current
path reads only "E:\". If there are still no folders or
patterns, it is possible that the USB flash drive be-
ing used has been given a different drive letter (this
can happen if there have ever been two USB sticks
plugged into the Pro-Stitcher computer at the same
time). Check the "F:\" drive by pressing on the small
black triangle located just to the right of the current
path and selecting the "F:\" drive (Figure 8).
Back: This button will move back in the file tree of
the USB flash drive. For example, if the current path
shows "E:\Designs\BL Designs\Continuous Line\",
then pressing "Back" will change the current path to
"E:\Designs\BL Designs" where one of the other yel-
low file folders may be selected.
Up/Down Arrows: These arrows are used to scroll up
and down through the pattern files on the right or
the yellow file folders on the left. Press and hold the
arrow to scroll through the files or folders.
All of the designs on the USB stick "E:\" drive can
also be found on the "D:\" drive under the "Designs"
folder. If you choose to save other designs to the
computer's hard drive, it is recommended that you
save them under the "Designs" folder to keep all your
designs in the same location.
Current Path
Figure 8
Load It
After identifying the desired pattern, tap on the file
name on the right-hand side of the screen to high-
light that pattern file and then press the "Load It"
button under the file name. The file will be loaded
and the user will be returned to the primary Library
screen.
Figure 7
Small Black Triangle
Page 17