Baby Lock Pro-Stitcher BLPS Instruction And Reference Manual page 7

4.
Make adjustments to the placement of the blue
fl exirack as necessary to align the blue fl exirack with
the front white gear on the Pro-Stitcher carriage
(Figure 3).
5.
Trim the fl exirack to length using a knife or wire
cutters if necessary (the blue fl exirack does not nec-
essarily need to extend the full width of the table and
can actually be a couple of inches shorter on either
end, if desired).
6.
At the ends of the blue fl exirack, use the four
small metal clamps (Page 3, B) to hold the ends
fi rmly in place (Figure 4a). The clamps have a hole
through the center and a lip on one end. The lip
should be on the side opposite the blue fl exirack.
Drill pilot holes using the 3/32" drill bit and then
attach the clamps as shown on either end of the blue
fl exirack using a Phillips screwdriver.
NOTE: Do not use the larger drill bit included in the
emergency repair kit...this is the wrong size for the
X-rack clamps!
As an alternative, choose to use one clamp at each
end using the lip of the clamp to slide over the last
tooth of the blue rack. (Figure 4b)
Figure 3
Lip
Figure 4 a
Lip
Figure 4 b
Page 5