Baby Lock Pro-Stitcher BLPS Instruction And Reference Manual page 11

7.
The small black cable with the black 3-connector
clip should be routed underneath the P-Pod
(Figure 12) and snapped into the quilting machine's
"Y" encoder (Figure 13).
The two black cables that run from the carriage up
to the computer should be clipped into the cable clip
under the rear handlebar as shown in Figure 12 to
help prevent these cables from getting caught on the
edges of the carriage.
8.
Verify that the Y-axis gear engages the blue
fl exirack for the Y-axis.
a. To do this, look from the back of the machine,
between the bottom of the quilting machine and
the top of the carriage. If the white gear is not high
enough to engage the blue rack above it (Page 3, H),
adjust the lever on the side of the carriage closest to
the back of the carriage (the Y-axis disengagement
lever) into the lowest position (the teeth of the gear
and the teeth of the rack should engage).
b. If horizontal adjustment is needed to ensure that
at least half the white gear and blue rack are inter-
locking, loosen the two screws that mount the Y-axis
bracket to the base plates and push the bracket in the
direction necessary while re-tightening the screws.
9.
With the power cable unplugged and both en-
gagement levers in the down position, ensure that as
the quilting machine is moved in both the X and the
Y directions, the corresponding gears are rotating
as well.
C-Pod
Figure 12
Y-encoder
Figure 13
P-Pod
Page 9