Getting Started
Setting up the Pro-Stitcher
The Pro-Stitcher should be installed as outlined in
the installation instructions on the previous pages.
USB Flash Drive
A USB fl ash memory stick is included with the
Pro-Stitcher and is pre-loaded with more than 200
designs. Plug this fl ash drive into one of the USB
ports located on the left-hand side or the bottom of
the Pro-Stitcher computer (Figure 1). The computer
may need to be tilted back to access the lower USB
port. It is not necessary to power down the Pro-
Stitcher to install or remove the USB fl ash drive, but
care should be taken not to remove the fl ash drive
while the system is saving to/or loading from
the drive.
Stylus
A stylus is located on the lower right-hand corner of
the screen. This may be used for more precise touch
screen control (Figure 2).
Page 14
Figure 1
Figure 2