Table of Contents
Advertisement
Computer/Touch Screen Monitor Assembly
1.
Remove the front handlebar from the front of the
quilting machine, making sure to fi rst disconnect the
handlebar cable from the side of the head and then
remove the three hex-head bolts with a 5mm Allen
wrench.
If it is diffi cult to remove the cable on the quilting
machine, fi rst remove two of the hex-head bolts and
then loosen the third. Next, rotate the handlebar
slightly to allow easier access to the handlebar cable.
2.
Make sure the three handlebar bolts are in the
front handlebar and protruding out the bottom of the
handlebar (Figure 14).
3.
Position the handlebar over the computer brack-
et so that the screws go through the three holes in
the bracket (Figure 15).
4.
Secure the handlebar and bracket in place on the
machine head using the three handlebar bolts.
Page 10
Figure 14
Figure 15
Hide quick links:
Advertisement
Table of Contents
