Pulse Speed Selection - Panasonic KX-TD308 Installation Manual

4.6 Outside Line Programming
Description
Selection
Default
Programming
Conditions
Feature References

Pulse Speed Selection

An outside line set for pulse or call blocking mode in program
[402] "Dial Mode Selection" can have two pulse rates, 10 pps (low)
and 20 pps (high). This program sets the pulse speed for each
outside line set to pulse or call blocking mode.
• Outside line (CO) number: 1 through 3,
• 10 pps / 20 pps
All outside lines – 10 pps
1. Enter 403.
Display: 403 PULSE SPEED
2. Press NEXT.
Display: CO Line NO?
3. Enter an outside line number.
To enter outside line number 1, you can also press NEXT.
Display example: CO1:10pps
4. Keep pressing SELECT until the desired selection is
displayed.
5. Press STORE.
6. To program another outside line, press NEXT or PREV, or
SELECT and the desired outside line number.
7. Repeat steps 4 through 6.
8. Press END.
• To assign all outside lines to one selection, press the
In this case, the display shows the contents programmed for outside line
1.
• The pulse speed required is determined by the outside or PBX line.
• Program [990] "System Additional Information, Field (17) and Field
(21)" are used to select a pulse break ratio and inter-digit pause, if
needed.
Section 3, Features
Dial Type Selection
( =all outside lines)
key in step 3.
System Programming
403
4-97