Panasonic KX-TD308 Installation Manual page 232

U
Conditions
Programming References
Feature Reference
Operation References
—User Manual
3-168 Features
• UCD can be used in the following cases:
a) The floating number of UCD is assigned as the Direct In Lines
(DIL) 1:1 destination.
b) The floating number of UCD is assigned as the Intercept Routing
destination.
c) The floating number of UCD is dialed from an extension.
d) The floating number of UCD is dialed from DISA (Direct Inward
System Access)
• This feature requires assigning an UCD group in System Programming.
An extension cannot belong to two or more UCD groups.
• The floating number can be assigned on an UCD group basis. The
UCD group is based on the extension group.
• It is possible to set the log-in or log-out status on an extension basis.
An UCD call can be sent to an extension in log-in status within the
UCD group, but cannot be sent to extensions in log-out status. If the
extension would like to leave the group temporarily, the extension sets
the log-out status by the feature number to prevent UCD calls being
sent to his/her extension. When the extension re-joins the group, the
extension sets the log-in status.
• There should be at least one extension that is in log-in status.
Section 4, System Programming
[106] Station Hunting Type
[602] Extension Group Assignment
[813] Floating Number Assignment
Section 3, Features
Extension Group
Log-In / Log-Out
DPT Features, Standard Telephone Features
Uniform Call Distribution (UCD)
3 Features
Station Hunting