Error Tone Output Setting (Error Tone) - Fostex PD-6 Operation Manual

PD-6 DVD Location Recorder (Chapter 7: Setup mode)

Error tone output setting (Error tone)

96
The "Error tone" menu selects whether generating the error tone (warning tone) or
not for each of four kinds of troubles (see below) independently. The error tone is
generated from the internal monitor speaker (or headphones).
On the "Error tone" menu screen, you can select "On" or "Off" of the error tone for
"Write error", "Input clip" and "BATT warning", as well as can set the time for "Disk
warning".
<Available conditions for generating the error tone>
The name in the bracket at the end of each condition shows each item name of the Error
tone menu.
1. A write error happens during recording. [Write error]
2. The peak indicator lights because of the input overload during recording. [Input
clip]
3. The internal battery voltage drops below the level set by the "BATT warning" menu.
[BATT warning]
4. The remaining recording time of a disk gets under the specified time. [Disk warning]
<Write error>
Option
When the peak indicator lights because of the input overload during
Off
recording, the error tone is not generated.
When the peak indicator lights because of the input overload during
On (default)
recording, the error tone is generated.
<Input clip>
Option
When the peak indicator lights continuously because of the input overload,
Off
the error tone is not generated.
When the peak indicator lights continuously because of the input overload,
On (default)
the error tone is generated.
<BATT warning>
Option
When the internal battery voltage drops below the level set by the "BATT
Off
warning" menu, the error tone is not generated.
When the internal battery voltage drops below the level set by the "BATT
On (default)
warning" menu, the error tone is generated.
Comment
Comment
Comment
flashing