How To Make Setup Menu Setting; Adjusting The Real-Time Clock (Adjust Rtc) - Fostex PD-6 Operation Manual

PD-6 DVD Location Recorder (Chapter 7: Setup mode)

How to make Setup menu setting

Adjusting the real-time clock (Adjust RTC)

90
Some Setup menus have the dedicated screens for editing, while others do
not have the dedicated screens and can be edited on the primary screen.
A menu of the former type has "
type does not have "
The following describes how to make settings of the "Adjust RTC" and "Digital
out" menus as the examples of the former and latter types, respectively.
You can make editing of each menu by the similar procedure as either of
these examples.
The "Adjust RTC" menu allows you to check and edit real-time clock data.
1. Select the "Adjust RTC
The display changes to show the screen on which the current real-time clock is
shown.
2. To edit the current clock data, press the [ENTER] again.
The second digits in the clock data flash. You are now able to edit the clock
data.
3. Use the [SEL] dial (or the numeric keys) to enter the desired value at the cursor
(flashing) position.
You can move the cursor position using the [
For each digit, you can enter the value within the range shown below.
Cursor position
"y" (year)
"m" (month)
"d" (day)
4. After editing the clock data, press the [ENTER] key to make the editing effective.
<Note>
To set the clock precisely, set the clock data to a near future time and press
the [ENTER] key synchronizing with the time signal.
5. Press the [EXIT] key to exit the Setup mode.
" on the right, while a menu of the latter
".
" menu and press the [ENTER] key.
Value range Cursor position
00 ~ 99
01 ~ 12
01 ~ 31
SKIP/CURSOR
Value range
"H" (hour)
"M" (minute)
"S" (second)
flashing
] keys.
00 ~ 23
00 ~ 59
00 ~ 59