Monitoring Recording Signals - Fostex PD-6 Operation Manual

PD-6 DVD Location Recorder (Chapter 5: Recording/playback)

Monitoring recording signals

64
You can monitor recording signals via headphones (or the internal monitor
speaker). While a plug is inserted to the [PHONES] jack, the internal speaker
automatically turns off, and you can monitor the signals only via headphones.
The monitor level can be adjusted by the [MONITOR] control. This control is
a push-lock type. By pushing the head of the control, the control comes out
and you can rotate the control to adjust the level. Pressing the control again
puts it inside the panel. To turn off the monitor sound completely, rotate
the control fully counterclockwise until it clicks.
<Note>
While running the PD-6 with the internal battery, we recommend not to raise the
monitor volume more than required. Raising the volume consumes more battery
power.
The monitor signal can be selected by the following switch settings.
SOLO monitor select switch
[MONITOR] control
[PHONES] jack
• Monitor mode select switch
Selects the monitor mode from among SOLO, ST and MONO.
Monitors a single track/input channel in mono.
SOLO
Monitors a stereo mix of tracks/input channels.
ST
MONO
Monitors a mono-mix of tracks/input channels.
• ST/MONO monitor select switch
When the monitor mode select switch is set to "MONO" or "ST", this switch selects
the tracks/input channels to be monitored.
• SOLO monitor select switch
When the monitor mode select switch is set to "SOLO", this switch selects the track/
input channel to be monitored. Note that, when the monitor mode select switch is
not set to "SOLO", this switch is not effective.
Monitor mode select switch
ST/MONO monitor select switch