Choosing The Single Or Repetitive Mode; Rom Test With Test Results - HP 16500A Service Manual

HP 16500A/16501A - Service
3. Touch the Run field, slide your finger downward to the Single, Repetitive or Cancel field, then lift
your finger off the screen. If the Cancel field is selected, the test sequence is not started. See
figure 6-12.
In the Single mode, the test is done only once. In the Repetitive mode, the test repeats itself until the
Stop or Done field is touched. The test results are also shown on this screen. The run column contains
the number of times the test was performed and the failures column contains the number of times the test
failed. See figure 6-13. The run/fail count is reset to zero when the Done field is selected.
4. To exit the ROM Test, touch the Done field. The Mainframe Test menu is displayed. Note that the
test status has changed to either PASSED or FAILED.
6-14
Figure 6-12. Choosing the Single or Repetitive Mode
Figure 6-13. ROM Test with Test Results