Endplate Overlap - HP 16500A Service Manual

HP 16500A/16501A - Installation
5. Reposition all cards and filler panels so that the endplates overlap properly.
6. Firmly seat the bottom card into the backplane connector of the mainframe. Keep applying
pressure to the center of the card endplate while tightening the thumb screws finger tight.
Repeat for all cards and filler panels in a bottom to top order. See figure 2-12.
Any filler panels that are not used should be kept for future use. Filler panels
must be installed in all unused card slots for correct air circulation.
2-14
Note
Figure 2-12. Endplate Overlap