Table of Contents
Advertisement
NOTE
NOTE
General Information
Replaceable Parts
Replaceable Parts
Table 1-7 lists all replaceable parts available for the Agilent 346A/B/C
Noise Sources. Figure 1-10 shows a typical Noise Source being prepared
for parts replacement at modular level by removing the four end screws
(two at each end).
If the Agilent 346A/B/C is opened and parts replaced, the Noise Source
will require calibration.
Due to a parts change, adjustment of the bias current may be necessary
for the product to meet its ENR specifications when parts are replaced in
older units. Installation Note 00346-90137 details the adjustment
process for the 346A and 346B. Installation Note 00346-90140 details the
adjustment process for the 346C. Both are supplied with their
appropriate replacement parts.
To order parts contact your local Agilent Technologies Sales and Service
Office.
26
Chapter 1
Hide quick links:
Advertisement
Table of Contents
