NOTE
Figure 1-3
General Information
Description
Warranty
The noise sources are warranted and certified as indicated in this
manual. Connector damage resulting from improper use is not covered
under warranty.
Equipment Available But Not Supplied
The following equipment is available from Agilent Technologies for use
with the noise sources:
• 8710-1766: 3/4" Torque Wrench (APC-7)
• 5060-0344: 9/16" Torque Wrench (APC-3.5)
Agilent/HP Model 346B Noise Sources with serial prefixes of 2037A and
below, have an APC-3.5 connector of a different configuration (See Figure
1-3). The 9/16" torque wrench will not fit these older models.
Agilent/HP Noise source with Older APC-3.5 Connector
Options
The Agilent 346A and 346B Noise Sources are available with the
following output connector options:
• Option 001, Type-N (male)
• Option 002, APC-7
• Option 004, Type-N (female)
Since the APC-7 and Type-N connectors do not operate up to 26.5 GHz,
no output connector options are available for the Agilent 346C.
12
Chapter 1