Figure 111 Configuration >Firewall > Edit; Table 82 Configuration >Firewall > Edit - ZyXEL Communications Vantage CNM User Manual

Vantage CNM User's Guide
Figure 111 Configuration >Firewall > Edit
The following table describes the labels in this screen.
Table 82 Configuration >Firewall > Edit
LABEL
Active
Packet Direction
Action for
matched packets
Log
Alert
Source Address
Destination
Address
Available/
Selected Services
Custom Port
225
Check the Active check box to have the ZyXEL device use this rule. Leave it
unchecked if you do not want the ZyXEL device to use the rule after you apply it
Use the drop-down list box to select the direction of packet travel to which you want
to apply this firewall rule.
Select whether to Block (silently discard) or Forward (allow the passage of)
packets that are traveling in the selected direction.
This field determines if a log is created for packets that match the rule (Match),
don't match the rule (Not Match), both (Both) or no log is created (None). Go to
the Log Settings page and select the Access Control logs category to have the
ZyXEL device record these logs.
Check the Alert check box to determine that this rule generates an alert when the
rule is matched.
Click Add to add a new address, Edit to edit an existing one or Delete to delete
one. Please see the next section for more information on adding and editing source
addresses.
Click Add to add a new address, Edit to edit an existing one or Delete to delete
one. Please see the following section on adding and editing destination addresses.
Highlight a service from the Available Services box on the left, then click >> to
add it to the Selected Services box on the right. To remove a service, highlight it in
the Selected Services box on the right, then click <<.
DESCRIPTION
Chapter 12 Configuration > Firewall