Figure 13-3 Ip Routing Policy; Table 13-2 Ip Routing Policy - ZyXEL Communications Prestige 650ME User Manual

Prestige 650ME ADSL Bridge
Type a number from 1 to 6 and press [ENTER] to display Menu 25.1.1 – IP Routing Policy as shown
next. This menu allows you to configure a policy rule.
Policy Set Name= test
Active= Yes
Criteria:
IP Protocol
Type of Service= Normal
Precedence
Source:
addr start= 1.1.1.1
port start= 20
Destination:
addr start= 2.2.2.2
port start= 20
Action= Matched
Gateway addr
Type of Service= Max Thruput
Precedence
FIELD
Policy Set Name
Active
Criteria:
IP Protocol
Type of Service
Precedence
Packet Length
Len Comp
13-4
Menu 25.1.1 - IP Routing Policy
= 6
= 0
= 192.168.1.1
= 0
Press ENTER to Confirm or ESC to Cancel:

Figure 13-3 IP Routing Policy

Table 13-2 IP Routing Policy

This is the policy set name assigned in Menu 25 – IP Routing Policy Setup.
Press [SPACE BAR] and then [ENTER] to select Yes to activate the policy.
IP layer 4 protocol, for example, UDP, TCP, ICMP, etc.
Prioritize incoming network traffic by choosing from Don't Care, Normal, Min
Delay, Max Thruput, Min Cost or Max Reliable.
Precedence value of the incoming packet. Press [SPACE BAR] and then
[ENTER] to select a value from 0 to 7 or Don't Care.
Type the length of incoming packets (in bytes). The operators in the Len
Comp (next field) apply to packets of this length.
Press [SPACE BAR] and then [ENTER] to choose from Equal, Not Equal,
Less, Greater, Less or Equal or Greater or Equal.
Packet length= 40
Len Comp= N/A
end= 1.1.1.1
end= 20
end= 2.2.2.2
end= 20
Log= No
DESCRIPTION
IP Policy Routing